• By proyecting with the machine leaves soft-hard the material.
• This can occur because the shirt, the rotor, or buzzer beater for excessive wear. It is recommended to review these items and replace them with new ones.

• Not enough water pressure in the machine.
• The pump can be spinning in reverse, so it is recommended to turn one phase to another in the plug for the hose, or even the pump is badly primed.

• The machine does not stop when we cut the air from the lance projection/projection launches.
• The phase switch has dust or dirt, so it should be replaced by a new one, or it may be poorly regulated, so it is advisable its proper regulation.

• Starting engine but the water does not rise.
• The solenoid valve has been closed and does not allow water flow. Change valve.

This page is password-protected. Please contact us to get a valid password

Calle del Horcajo, 20. Nave 12.
Polígono Industrial Las Arenas de Pinto.
28320 Pinto.
Madrid – Spain.
Tel: 916 912 073

comercial@putzfaster.com

Clave:

PF-4:

Last December was sent to the Middle East the star machine of our company: Plastering PF-4.

This is the first shipment of a series that will continue throughout 2010.

PUTZ-FASTER sympathizes with earthquake victims in Haiti, working with SPANISH RED CROSS to help the victims. SPANISH RED CROSS in Haiti is undertaking its biggest operation in its history after the tsunami in southern Asia, and PUTZ-FASTER has contributed its bit to promote this great work.

Our plaster sprayer PF-48 has conquered lands of South America, having a profound impact on the construction sector in Colombia.

We hope that this success will continue during 2010, and we continue to work with this Latin American country.