Videos

FAQ


  • By proyecting with the machine leaves soft-hard the material.
  • This can occur because the shirt, the rotor, or buzzer beater for excessive wear. It is recommended to review these items and replace them with new ones.
  • Not enough water pressure in the machine.
  • The pump can be spinning in reverse, so it is recommended to turn one phase to another in the plug for the hose, or even the pump is badly primed.
  • The machine does not stop when we cut the air from the lance projection/projection launches.
  • The phase switch has dust or dirt, so it should be replaced by a new one, or it may be poorly regulated, so it is advisable its proper regulation.
  • Starting engine but the water does not rise.
  • The solenoid valve has been closed and does not allow water flow. Change valve.


Leave a reply